No edit summary |
No edit summary |
||
Line 17: | Line 17: | ||
!Behavior | !Behavior | ||
|- | |- | ||
|0 | | rowspan="2" |0 | ||
|0 | |0 | ||
|<code>M02</code> and <code>M30</code> count parts | |<code>M02</code> and <code>M30</code> count parts | ||
|- | |- | ||
|''x'' > 0 | |''x'' > 0 | ||
|<code>M02</code>, <code>M30</code>, and <code>M''x''</code> count parts | |<code>M02</code>, <code>M30</code>, and <code>M''x''</code> count parts | ||
|- | |- | ||
|1 | | rowspan="2" |1 | ||
|0 | |0 | ||
|Part counting is disabled | |Part counting is disabled | ||
|- | |- | ||
|''x'' > 0 | |''x'' > 0 | ||
|Only <code>M''x''</code> counts parts | |Only <code>M''x''</code> counts parts | ||
|} | |} | ||
[[Category:OnTakt User Guide]] | [[Category:OnTakt User Guide]] |
Revision as of 12:40, 10 April 2023
To set up communication with a FANUC control, see FANUC FOCAS.
Part counting
Bit #0 of parameter 6700 determines which M-codes will cause the part counter (stored in parameter 6711) to increment.
- If it is set to 0:
M02
,M30
, andMx
(where x is the value of parameter 6710) will increment the part counter. - If it is set to 1: Only
Mx
(where x is the value of parameter 6710) will increment the part counter.
Parameter 6710 holds the M-code to use for part counting as described above.
- If it is set to 0, it will not be used at all.
6700#0 | 6710 | Behavior |
---|---|---|
0 | 0 | M02 and M30 count parts
|
x > 0 | M02 , M30 , and Mx count parts
| |
1 | 0 | Part counting is disabled |
x > 0 | Only Mx counts parts
|