No edit summary |
No edit summary |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
==Part counting== | ==Part counting== | ||
Bit #0 of parameter 6700 determines which M-codes will cause the part counter (stored in parameter 6711) to increment. | Bit #0 (PCM) of parameter 6700 determines which M-codes will cause the part counter (stored in parameter 6711) to increment. | ||
*If it is set to 0: <code>M02</code>, <code>M30</code>, and <code> | *If it is set to 0: <code>M02</code>, <code>M30</code>, and <code>M''x''</code> (where ''x'' is the value of parameter 6710) will increment the part counter. | ||
*If it is set to 1: Only <code>M''x''</code> (where ''x'' is the value of parameter 6710) will increment the part counter. | *If it is set to 1: Only <code>M''x''</code> (where ''x'' is the value of parameter 6710) will increment the part counter. | ||
| Line 13: | Line 13: | ||
{| class="wikitable" | {| class="wikitable" | ||
|+Behavior of parameters 6700 and 6710 | |+Behavior of parameters 6700 and 6710 | ||
!6700#0 | !6700#0 (PCM) | ||
!6710 | !6710 | ||
!Behavior | !Behavior | ||
|- | |- | ||
|0 | | rowspan="2" |0 | ||
|0 | |0 | ||
|<code>M02</code> and <code>M30</code> count parts | |<code>M02</code> and <code>M30</code> count parts | ||
|- | |- | ||
|''x'' > 0 | |''x'' > 0 | ||
|<code>M02</code>, <code>M30</code>, and <code>M''x''</code> count parts | |<code>M02</code>, <code>M30</code>, and <code>M''x''</code> count parts | ||
|- | |- | ||
|1 | | rowspan="2" |1 | ||
|0 | |0 | ||
|Part counting is disabled | |Part counting is disabled | ||
|- | |- | ||
|''x'' > 0 | |''x'' > 0 | ||
|Only <code>M''x''</code> counts parts | |Only <code>M''x''</code> counts parts | ||
|} | |} | ||
[[Category:OnTakt User Guide]] | [[Category:OnTakt User Guide]] | ||
Latest revision as of 12:06, 10 April 2023
To set up communication with a FANUC control, see FANUC FOCAS.
Part counting
Bit #0 (PCM) of parameter 6700 determines which M-codes will cause the part counter (stored in parameter 6711) to increment.
- If it is set to 0:
M02,M30, andMx(where x is the value of parameter 6710) will increment the part counter. - If it is set to 1: Only
Mx(where x is the value of parameter 6710) will increment the part counter.
Parameter 6710 holds the M-code to use for part counting as described above.
- If it is set to 0, it will not be used at all.
| 6700#0 (PCM) | 6710 | Behavior |
|---|---|---|
| 0 | 0 | M02 and M30 count parts
|
| x > 0 | M02, M30, and Mx count parts
| |
| 1 | 0 | Part counting is disabled |
| x > 0 | Only Mx counts parts
|