(Created page with "== Unboxing == === Verify box contents === * Industrial computer * Power supply * Ethernet cable === Install hardware === # Place the IPC in a safe location. # Connect the Ethernet cable to a router or working Ethernet jack. # Connect the power cable to the wall and the IPC. # The IPC should begin booting and appear on the network. == Network requirements == === Local network traffic === The OnTakt server needs '''outgoing access''' to each machine control it will...") |
No edit summary |
||
| Line 44: | Line 44: | ||
# After the key is applied, click the Install button under OnTakt. | # After the key is applied, click the Install button under OnTakt. | ||
# After installation is completed, return to the Services page and launch OnTakt. | # After installation is completed, return to the Services page and launch OnTakt. | ||
[[Category:OnTakt]] | |||
Revision as of 13:26, 29 August 2022
Unboxing
Verify box contents
- Industrial computer
- Power supply
- Ethernet cable
Install hardware
- Place the IPC in a safe location.
- Connect the Ethernet cable to a router or working Ethernet jack.
- Connect the power cable to the wall and the IPC.
- The IPC should begin booting and appear on the network.
Network requirements
Local network traffic
The OnTakt server needs outgoing access to each machine control it will read data from. The specific port used for a machine depends on the control type and is usually even configurable on the control. The port should be specified in the machine’s URL in OnTakt.
The OnTakt server needs incoming access from the PCs that will access its web interface on the following ports:
- 80/tcp – Homepage
- 8710/tcp – Inspection HTTP
- 8711/tcp – Inspection HTTPS
- 8720/tcp – OnTakt
For mDNS discovery, it will need outgoing access on 5353/udp to 224.0.0.251 (IPv4) and/or ff02::fb (IPv6) as well as incoming access on that same port from the PCs that will access its web interface.
Internet traffic
An internet connection is not required to run or use OnTakt. However, it makes applying updates much easier. If you would like to allow the OnTakt server to access the internet but limit what it can connect to, set up a firewall rule that allows outgoing access to only the following hosts:
- us.archive.ubuntu.com: 80/tcp and 443/tcp
- central.ontakt.live: 443/tcp
- pkg.central.ontakt.live: 443/tcp
First-time setup
The IPC must be provisioned and connected to the network first.
- Get the IP address of the device from your router or IT department. Ideally, this address will be statically assigned so it never changes.
- Go to this IP address in a browser.
- Switch to the Settings tab at the top.
- Apply the provided license key in Options → Advanced → Upload new license key. This will allow downloading software.
- After the key is applied, click the Install button under OnTakt.
- After installation is completed, return to the Services page and launch OnTakt.