Siemens SINUMERIK: Difference between revisions

Revision as of 15:44, 5 September 2023

Press the key.
Switch to the the Setup interface at the bottom of the screen.
Press the softkey page button at the bottom right of the screen.
Open the window.
Switch to the "All options" tab at the top right.
Press the button to the right of the screen.
Enter "OPC" in the search field.
Press at the bottom right of the screen.
When "Access MyMachine / OPC UA" is highlighted, press the Cancel button at the bottom right of the screen.
Check the "Set" box for the option if it is not already checked and then press the Back button at the bottom right.
If the option was not already enabled, restart the control.

TK

Set the following options in the machine setup area:

System: OPC-UA
Model: SINUMERIK 840D sl
NC URL: opc.tcp://IP, where IP is the IP address of the control.
NC authentication: username:password, where username and password are the OPC-UA username and password configured in the OPC-UA settings on the control.

@@ Line 5: / Line 5: @@
 # Press the [[File:MENU SELECT.webp|alt=MENU SELECT]] key.
 # Switch to the the Setup interface at the bottom of the screen. [[File:Setup_softkey.webp|none|frame]]
-# Press the softkey page button at the bottom right of the screen. [[File:Softkey_switcher.webp|frame|left]]
+# Press the softkey page button at the bottom right of the screen. [[File:Softkey_switcher.webp|frame|none]]
 # Open the [[File:Licenses softkey.webp]] window.
 # Switch to the "All options" tab at the top right.[[File:License_all_options.webp|none|frame]]